ITEM METADATA RECORD
Title: A study of degradation of laser-sintered moulds using wear tests
Authors: Kumar, S. ×
Kruth, Jean-Pierre
Van Humbeeck, Jan
Voet, A. #
Issue Date: 2009
Publisher: MCB University Press
Series Title: Rapid Prototyping Journal vol:15 issue:2 pages:104-110
Abstract: Purpose – Surface changes like wear or local plastic deformation occurring during service of a mould make it unsuitable for further use and determine its life-time. The performance of the mould and its design are important aspects that influence its longevity. The purpose of this paper is to study the behaviour of mould materials manufactured by laser sintering, a type of rapid manufacturing process, and to explain their relative in-service performance.
Design/methodology/approach – Mould specimens were made by two laser-sintering machines (a DTM Sinterstation and an EOSint M250 Xtended equipped with CO2 lasers) using two iron-based commercial powders, i.e. LaserForm ST-100 and DirectSteel 20 V1, respectively. They have been subjected to two types of wear tests, i.e. bidirectional fretting and unidirectional pin-on-disc tests, under loading conditions leading to wear and/or plastic deformation of the specimens. The results obtained show similar trends to that obtained from the real-life performance of polymer injection moulds manufactured using such materials and processes.
Findings – LaserForm is a better material for injection moulds material than DirectSteel; however, and its performance will deteriorate under impact injection moulding conditions where plastic surface deformation will occur in addition to abrasive wear. Both materials show high coefficient of friction, their performance will be enhanced by redesigning the composition of the powders by incorporating hard and low friction components. The methodology adopted here for investigating the surface degradation behaviours of materials is able to give sufficient and reliable information about the wear behaviour of mould materials for practical applications.
Originality/value – It is concluded that the wear tests used here are suited to characterize the in-service mould wear strength, and such tests could be preferably used to shorten the mould development/validation time.
ISSN: 1355-2546
Publication status: published
KU Leuven publication type: IT
Appears in Collections:Physical Metallurgy and Materials Engineering Section (-)
Production Engineering, Machine Design and Automation (PMA) Section
× corresponding author
# (joint) last author

Files in This Item:
File Description Status SizeFormat
pub04843.pdfMain article Published 235KbAdobe PDFView/Open Request a copy

These files are only available to some KU Leuven Association staff members

 




All items in Lirias are protected by copyright, with all rights reserved.

© Web of science